JDSU NT850 Guia do Utilizador descarregar pdf (Página 72)

Chapter 5 Viewing Properties and Modifying Settings

Viewing Unit Properties

56 LanScaperPRO Network Tester User’s Guide

The following last DHCP values are shown:

– MyIP: The IP address for the LanScaperPRO.

– Host: The IP address of the DHCP server on the

LAN.

– Rtr: The IP address of the router on the LAN.

– DNS Srvr: The IP address of the DNS server

accessible from the LAN

– Netmask: The Netmask in use.

Any 0.0.0.0 entries mean that the last DHCP server

did not provide the requested information. If all

entries are 0.0.0.0, the most likely cause is that

DHCP ON mode was selected, but the LAN did not

provide a DHCP server.

Viewing the

unit MAC

address

The MAC address screen displays the factory-set Media

Access Control (MAC) number for the specific LanScap-

erPRO unit. Every Ethernet-interfaced device must have

a universally unique identifier to be used as its address.

This information is provided as a convenience to the user.

To view the unit MAC address

1 Access the Properties menu. (See “Accessing the

Properties menu” on page 54.)

2 Scroll through the menu options using the arrow keys

until MAC address is highlighted.

3 Press the SEL key.

The MAC address screen appears and displays the

MAC address for the unit, as shown in Figure 25 on

page 57.

LanScaperPRO_User_Guide.book Page 56 Friday, January 25, 2008 1:14 PM

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 105 106

Sem comentários

JDSU NT850 Guia do Utilizador Página 72