JDSU NT850 Guia do Utilizador descarregar pdf (Página 67)

Chapter 4 Performing Cabling Tests

Performing Tone Generator Tests

LanScaperPRO Network Tester User’s Guide 51

7 Press the TEST key to begin generating the tone.

If the tone is generated successfully, Tone is

active is displayed at the bottom of the screen.

8 To change tone options, press the QUIT key to stop

the tone. Press QUIT again to exit this mode.

NOTE

To exit Pair or Pin change mode without changing

the setting, press the QUIT key.

NOTE

For strongest signal, do not connect to a remote. Due

to the shielding effect of twisted pairs, the strongest

signal is obtained by having one wire of a pair carry

tone. Selecting a single pin instead of a pair will do this.

LanScaperPRO_User_Guide.book Page 51 Friday, January 25, 2008 1:14 PM

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 105 106

Sem comentários

JDSU NT850 Guia do Utilizador Página 67