JDSU NT850 Guia do Utilizador descarregar pdf (Página 49)

Chapter 3 Performing Network Tests

Performing Hub Flash Tests

LanScaperPRO Network Tester User’s Guide 33

the host is the Target IP address, which is always manu-

ally entered.) If no response is received, the tester cannot

do any pinging on that LAN. In that case, the DHCP off

state must be selected, and all of the ping setup para-

maters must be manually entered. The next ping test will

then attempt to communicate with those parameters.

Performing Hub Flash Tests

The Hub Flash test is used to help identify a hub or switch

port.

1 Connect the LanScaperPRO to a jack or plug at the

workstation location for which the Ethernet port is to

be located.

2 Access the Network Test Menu. (See “Accessing the

Network Test Menu” on page 22.)

3 Scroll through the menu options using the arrow keys

until Hub Flash is highlighted.

4 Press the SEL key.

The Hub Flash screen appears.

Figure 13 The Hub Flash screen

LanScaperPRO_User_Guide.book Page 33 Friday, January 25, 2008 1:14 PM

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 105 106

Sem comentários

JDSU NT850 Guia do Utilizador Página 49