JDSU TP500 Guia do Utilizador Página 1

LanRoamerf Tester/AnalyzerUser's Guidewww.jdsu.com/hbn

7Interpreting ResultsDefinition of Errors – (See “Examples of Wiring Errors”) The four fault lights are discussed below in order of severity. The seve

8Split Pair – A split pair is an error in the twisting of the wires together within the cable. The cables generally are made up of eight wires twisted

911111111112222222222333333333344444444445555555555666666666677777777778888888888OPENSPLT PAIRREVERSEMISWIRESHORT1-23-64-57-8= OFF= ON= FLASHSPLIT PAI

10Main Unit Results – The main unit indicates the beginning of a test by flashing the pair lights in sequence top to bottom. The cable is then tested

11If there was an error, the results are displayed for twice as long. If the lights for the pairs expected are on, the cable is good.Debug Mode – (Se

121 12 23 34 45 56 67 78 8SPLT PAIRREVERSEMISWIRESHORT1-23-64-57-8= OFF= ON= FLASHEthernet Up-Link Cable ExampleSPLT PAIRSPLT PAIRSPLT PAIRSPLT PAIRRE

13Battery ReplacementWhen the battery low light is on while generating tone or testing cables, the battery should be replaced as soon as practical. Th

14SpecificationsElectricalBattery Life, typical alkaline — times are for the full capacity of the battery used continuously in one of the following mo

15WarrantyJDSU guarantees that its products will be free of all defects in material and workmanship. This warranty extends for the period of 12 months

16is the responsibility of the equipment owner to return the equipment to JDSU for appropriate disposal. If the equipment was imported by a reseller w

17ShippingBefore returning any product to JDSU, you must first request a Return Merchandise Authorization Number by contacting our Customer Service De

18Notes:

19Notes:

Contact Information:808 Calle PlanoCamarillo, CA 93012USARegional SalesNorth AmericaTel: +1 805 383 1500Fax:+1 805 383 1595Latin AmericaTel: +55 11 55

Green Pair LightsShield LightTone LightTone ButtonAmber Pair LightsDetachable RemoteFault LightsBattery LowBattery Cap

1Warning!Do not attach to energized cables. The LanRoamer™ may be damaged.Caution!Improperly crimped or un-crimped plugs can damage the jacks on the L

2Features Auto-on and auto-off when testing cables, just plug both ends into tester! Cable test results displayed on main unit and remote unit, in les

3DescriptionThe main unit has four green pair lights, a green shield light, four red fault lights, a red battery low light and a green tone light. The

4Instructions for UseLanRoamer™ powers off automatically after 5 minutes of continuously testing a cable. Disconnecting the cable restores normal func

5To Test Installed Cable (Office jack to patch panel)1) Remove remote unit from main unit by sliding remote towards top of the main unit.2) Attach o

6To Test Coax (Requires optional RJ45-to-coax adapter)1) Plug the RJ45 to F coax adapters into the remote and main units.2) Attach cable to be teste